Moeller Marine

Fueling the Fun

Aftermarket Downloads

CARB Regulations

The California Air Resources Board (CARB) has approved new emission and spill-control regulations for portable fuel containers that came into effect in California on January 1, 2001. According to CARB, traditional gas cans account for about 87 tons of smog-forming pollution a day in California. This is equivalent to emissions generated by about 1 million cars.

All new fuel cans manufactured, sold, or supplied for use in California after Januarry 2001 must meet with specific performance standards.

To review documents, please click on CARB Regs Postcard, Moeller CARB EPA Advisory, and EXECUTIVE ORDER G-11-083.


DYK Jerry Cans

07378_spout-in-72dpi
There are estimated to be 9.2 million residential and nearly 600,000 commerical gas cans in the state of California alone with an additional 1.9 mllion new cans sold yearly. The culminating smog-forming pollution emitted from these cans equals the emissions from nearly 1 million cars.
In an effort to reduce these issues, the California Air Resource Board (CARB) approved new emission regulations to help this problem.
Please click here to read further.


Ethanol Guidelines Information Sheet

The EPA is responsible for setting Federal Guidelines that regulate the content in engine fuels. WIth a governmental push for blended fuels and bio-fuel development from renewable sources, ethanol has gained the energy spotlight as a fuel additive solution.

Engine fuel requires a certain octane rating in order to prevent the premature ignition that causes damaging engine knocking. Gasoline alone has a tendency to ignite prematurely during engine compression, which is why additives with a high octane rating must be blended with it.
Ethanol is a common additive to blend the fuels with, and while ethanol may not pose the environmental hazards of other gas additives, the chemical properties of ethanol have the potential to cause severe damage to engine systems.

Click here to find out more information regarding the potential hazards and warnings regarding the use of ethanol.


Water Sep. Fuel Filter Information Sheet

Moeller brand fuel and water separating filters are innovated for gasoline use on all outboard engines. Our design eliminates the use of common filters on most marine engines, including Mercury, Yamaha, Suzuki, Honda, Tohatsu, and Nissan engines.

For most information regarding our filters, please click here.


Flanging Tool Instructions

020704-00_07273-72dpi
By consumer request, Moeller is now providing an electronic version of the Installation How-To-Guide for our Drain Tube Flanging Tool.
You may download the installation guide by clicking here.


Fuel Tank Installation Instructions

032623_07134-72dpi
Every permanents fuel tank is designed for functional durability and performance. For your safety and for best results, pre-read the following instructions before installation.
Click here for a complete guide on how to install a Moeller Permanent Below Deck Fuel Tank.
In order to obtain optimal performance from your newly installed permanent fuel tank, you may want to consider some information and recommendations to the upkeep of the fuel tank. Please Click here for further information.
PLEASE NOTE: If you are unsure of any of these detailed procedures, seek professional assistance!


Gauge & Sending Unit Wiring Instructions

Diagram: Gauge and sending unit wiring diagram and industry recommendations – click here for PDF.

Includes: schematic explanation of wiring colours – recommended marine wiring colour code direct current system – under 50 volts.


Universal Electric Fuel Sender Instructions

035722-10_07151-72dpi
Every piece has been pre-inspected to guarantee full range of calibrated readings and designed for gasoline applications. You can also use diesel if separate return line is available. For your safety and for best results, please read the following instructions completely before installation. Please click here for a complete guide to installation.


Tank Cradle Hold Down Kit Instructions

Installation How-To-Guide.

You may download the installation guide by click here.


Certifications

COC Certifications

Click below to view the United States Environmental Protection Agency Certificate of Conformity with the Clean Air Act of 1990:
2014 EPA COC for Primer Bulbs page 1
2013 EPA COC for Fuel Tanks page 1 page 2
2011-12 EPA COC for Fuel Lines page 1 page 2
CARB EO for Portable Fuel Tanks
CARB EO for Primer Bulbs
CARB EO for Fuel Lines

CE Certifications

Click below to view the certificates
200HPI
220HPI
235HPI
250HPI
265HPI
275HPI
285HPI
300HPI

Gas Walker

Gas Walker Competent Authority Approval

Scepter Certificates

CSCPPMDRNSTR-001
CSCPPTANK001-002
SCEPTER_TANK


MSDS

Click below to view the Material Data Safety Sheets

Paints
Metallic Paints
Yellow and Green Zinc Chromate
Clear Coat
Green Zinc Phospate
Yellow Zinc Phospate
Flat Black
Olive Drab
Hot Rod White
Platinum Gray
Red Oxide
Zinc Cold Galvanizing
Zinc Chromate Spray Paint
Bright Zinc Galvanize
High Heat Charcoal
High Heat Charcoal
High Heat White
High Heat Aluminum
High Heat Black
Metallic Black
Phantom Black


EPA Portable Fuel Tank Operating Instructions

EPA Portable (12-gallon & under) Fuel Tank Operating Instructions

Click here to download instructions


ABC’s of Painting

Click here to learn the ABC’s of Painting.


Non Barrier

Changes in topside tank configurations that you need to know going forward. Click here.

Gas Walker Instructions

730025_08413-gas-walker-gw29_wi
Click here to download Gas Walker Installation Instructions.


Technical Support

Visit our Customer Support page.

Moeller Marine Products |
©2016